Router# show tech-support | append disk1:showoutput.txt In the following example, output from the show tech-support command is redirected to an existing file on Disk 1 with the file-name of "showoutput.txt." This output is added at the end of any existing data in the file. This command adds the show command output to the end of the specified file. To display all URL prefixes that are supported for this command, use the show command | append ? command. This command was integrated into Cisco IOS Release 12.2(13)T. Alternatively, you can specify network locations using the following syntax:įtp: location] / directory] / filename Prefixes can be local file locations, such as flash: or disk0. The Cisco IOS File System (IFS) uses URLs to specify the location of a file system, directory, and file. The addition of this syntax redirects the command output to the file location specified in the Universal Resource Locator (URL). Show command | append url Syntax Description To redirect and add the output of any show command to an existing file, use the show command | append command in privileged EXEC mode. Sets the revision number for the MST configuration.ĭisplays the information about the MST protocol. Maps a VLAN or a set of VLANs to an MST instance. This example shows how to display the current configuration: Router(config-mst)# show current The display output from the show pending command is the edited configuration that will replace the current configuration if you enter the exit command to exit MST configuration mode.Įntering the show command with no arguments displays the pending configurations. This command was integrated into Cisco IOS Release 12.2(33)SRA. Support for this command on the Supervisor Engine 2 was extended to Release 12.2(17d)SXB. Support for this command was introduced on the Supervisor Engine 720. MST configuration submode Command History (Optional) Displays the edited configuration that will replace the current configuration. (Optional) Displays the current configuration that is used to run MST. To verify the Multiple Spanning Tree (MST) configuration, use the show command.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |